We all know that in every manufacturing industry, all need to use high-pressure compressed air, all need to use pneumatic booster pump (including gas booster pump, air pump, gas-liquid booster pump, etc.), the use of pneumatic booster pump inevitably causes problems, the following game, the causes and solutions of internal water of small pneumatic booster pump, gas booster pump, gas-liquid booster pump).
What is the reason of water inflow in the gas-liquid booster pump?
1. Because there is always water in the air, that is, the so-called air humidity, after compression, it will become supersaturated. The concentration of water in the air will be liquid water after analysis and compression to a certain extent. The moisture content of compressed air is related to the humidity of air. If the factory environment is too humid, the moisture content in the air will exceed the use standard.
2. Pneumatic booster pump (including gas booster pump, air booster pump, gas-liquid booster pump, etc.) has its own automatic water filter plug or automatic water filter plug of oil tank.
3. After installation, no corresponding dryer parts are installed or not in normal operation (the drying equipment fails to be detected and handled in time). Finally, the compressed gas treatment of the pneumatic booster pump is not timely, and there is still a lot of water after removal, which can not meet the requirements of normal use.
4. The following measures are not enough. In the production process where the gas quality requirements of pneumatic booster pump are very strict, there are usually precise filters and other facilities to perform secondary action on the gas and further purification until the production requirements.
This article comes from: gas-liquid booster pump more content please click: http://www.sdjingtuo.com we will provide a satisfactory service for your questions, welcome your call!