气液增压泵不会自动产生气体。它只是为增加气体压力而开发的产品，因此必须通过外部低压气体装置进口。线路驱动，两者之间的连接必须通过管道对接，运行过程中可能会因各种外界条件而出现低压设备。
The gas-liquid booster pump will not generate gas automatically. It is only a product developed to increase gas pressure, so it must be imported through an external low-pressure gas device. Line driven, the connection between the two must be connected through pipeline, and low-voltage equipment may appear due to various external conditions during operation.
有水分，这种水分会随着气管进入增压泵的气罐，导致气液增压泵入水。而这水会随着输入气管进入使用设备上的设备，如果要解决这个问题，一定要定期检查前端送风设备并进行清洁，罐内水分问题可以彻底解决前期工作准备好后，就剩下后期的维护了。
There is water, which will enter the air tank of the booster pump along with the gas pipe, resulting in water entering the gas-liquid booster pump. The water will enter the equipment on the equipment with the input pipe. If this problem is to be solved, the front-end air supply equipment must be regularly inspected and cleaned. The water problem in the tank can be completely solved. After the preliminary work is ready, the later maintenance is left.
1、
气液增压泵要定期加油，时刻保持气液增压泵内的油（月检）
1. The gas-liquid booster pump shall be refueled regularly, and the oil in the gas-liquid booster pump shall be maintained at all times (monthly inspection)
2、定期清理增压泵上的灰尘（增压泵具有自吸功能，容易将灰尘吸入内部，造成高压密封和气缸划伤）
2. Regularly clean the dust on the booster pump (the booster pump has a self-priming function, which is easy to suck the dust into the interior, causing high-pressure seal and cylinder scratch)
3、定期打开储气罐下方的排水阀将水排出（气流过大时气体会凝结水分）
3. Regularly open the drain valve under the air tank to drain the water (the gas will condense when the air flow is too large)
4、定期检查阀是否能正常使用，高压管路是否老化（1年一次）
4. Regularly check whether the safety valve can be used normally and whether the high-pressure pipeline is aged (once a year)
5、如有条件，定期更换密封圈（2年——一次）
5. If possible, replace the sealing ring regularly (2 years - once)
保养要点：如果保养不好，后期会影响增压系统和气体增压系统的使用寿命，所以购买增压系统后要注意现场使用环境是否灰尘过多，是否需要安装防尘罩，现场驱动气源是否有潮气，如果有，同时加干燥机和过滤器时间。
Key points of maintenance: if the maintenance is not good, the service life of the air pressurization system and the gas pressurization system will be affected later. Therefore, after purchasing the pressurization system, pay attention to whether the on-site operating environment is too dusty, whether the dust cover needs to be installed, whether the on-site driving air source has moisture, and if so, add the time of the dryer and filter.
The treatment method to prevent water from entering the gas-liquid booster pump has been explained to you. If you want to know anything about it, you can follow our website www.sdjingtuo COM, consult the customer service personnel.
