气液增压设备在长期使用后，可能会发生设备上的气液增压泵漏油的现象，有的从电磁阀处漏出来，有的从气口处漏出来，而有的则从端盖处漏出来。
When the gas and liquid supercharging equipment is used for a long time, the gas liquid supercharging pump may leak out of the equipment, some leak out from the solenoid valve, some leak out from the air inlet, and some leak out from the end cover.
气液增压泵出现问题，可能会严重影响生产。
The problem of gas liquid booster pump may seriously affect production.
1、在将气液增压泵接入气路前，必须将管路、气口、元件清洁干净，不能有灰尘和杂物等现象。
1. Before the gas liquid booster pump is connected to the gas path, the pipelines, air outlets and components must be clean and clean, and there must be no dust and sundries.
2、为保证气液增压泵泵体内的密封件的正常使用，请使用干燥、清洁的压缩气体，在进入缸体气源处加装有效的空气处理元件（三点组合）并按时加润滑油及排水处理。
2. To ensure the normal use of seals in the gas and liquid supercharging pump, use dry and clean compressed gas, add effective air treatment components (three points) into the cylinder gas source and add lubricating oil and drainage treatment on time.
3、控制系统必须依据气液增压泵系列产品动作程序编制。
3, control system must be based on gas liquid booster pump series action program.
4、气液增压系列产品根据泵的使用频率，高频率3个月更换液体介质（抗磨液压油），一般使用频率8个月更换液体介质（抗磨液压油）或者当油标管内液压油变成黑色或呈乳白色时，请更换液压油。
4, gas liquid supercharging series products change liquid medium (anti wear hydraulic oil) according to the frequency of pump, high frequency 3 months to replace liquid medium (anti-wear hydraulic oil), replace liquid medium for 8 months (anti wear hydraulic oil) or when the hydraulic oil in the oil pipe becomes black or milk white, replace hydraulic oil.
5、为确保气液增压泵工作的稳定性，建议您尽可能在三联件与气液增压之间加装一储气罐，确保气源稳定。
5, in order to ensure the stability of the gas liquid booster pump, it is recommended that you install an air storage tank between the triplet and the pressurized gas and liquid as far as possible to ensure that the gas source is stable.
6、如气液增压泵出力过大，请在增压进气口加装一个附逆止型减压阀。
6. If the gas liquid booster pump is too large, add a reverse pressure reducing valve to the pressurized intake port.
7、气液增压泵在更换液压油时，必须注意气口生胶带及杂物进入泵体，影响气液增压泵的寿命。
7, when replacing the hydraulic fluid, the gas liquid booster pump must pay attention to the gas inlet and the sundries entering the pump body, which will affect the life of the gas hydraulic booster pump.
