热线电话
0531-69951198
网站首页
关于精拓
产品展厅
新闻中心
原理选型
客户案例
在线留言
联系我们
网站公告:

新闻中心

济南精拓流体设备有限公司

电话:0531-69951198

邮箱:jingtuolt@163.com

传真:0531-69951198

地址:济南市历城区祝甸北路2号院

网址:http://www.sdjingtuo.com

常见问题

当前位置:首页 - 新闻中心 - 常见问题气体增压清洗时需要注意的

气体增压清洗时需要注意的事项

发布时间:2017-07-29 11:03:50   发布人:http://www.sdjingtuo.com
气体增压系统使用久了之后,里里外外都会有许多灰尘,这时候就需要对气体增压系统进行清洗,那么在清洗气体增压系统时都应该注意些什么事项呢?
After the gas pressurization system used for a long time, and will have a lot of dust, this time you need to clean the gas pressurization system, then in the cleaning gas pressurization system should pay attention to what matters?
1、不能用煤油、酒精或是其它腐蚀性液体,以防液压器元件、油箱等部件受到腐蚀,影响液压器的正常使用。
1, can not use kerosene, alcohol or other corrosive liquid, in order to prevent hydraulic components, fuel tanks and other parts of corrosion, affecting the normal use of hydraulic devices.
2、清洗气体增压系统时,液压泵运转和清洗介质加热应同时进行。因为,清洗油液的温度为五十摄氏度到八十摄氏度时,系统内的橡胶渣时很容易被除掉的。

2, cleaning gas pressurization system, the hydraulic pump running and cleaning medium heating should be carried out simultaneously. Because the temperature of the oil is fifty degrees Celsius to eighty degrees Celsius, the rubber residue in the system can be easily removed.
3、液压泵工作的时候进行间歇性的运转可以提高清洗效果。
3, hydraulic pump operation intermittent operation, can improve the cleaning effect.
4、我们应该在气体增压系统的清洗油路的回路上安装过滤器,这样可以过滤掉系统内大部分的杂质。
4, we should install the filter in the circuit of the cleaning circuit of the gas pressurization system, which can filter out most of the impurities in the system.
5、清洗液压泵的时间一般在四十八小时到六十小时之间,这是由系统的复杂程度和污染程度等因素决定的。
5, cleaning the hydraulic pump time is generally between forty-eight hours to sixty hours, which is determined by the complexity of the system and the degree of pollution and other factors.
6、清洗结束时,不要立即使液压泵停止运转,应该使其持续运转直到液压泵气温恢复正常,这样可以防止外界湿气使内部器件生锈。
6. At the end of the cleaning, do not immediately stop the hydraulic pump, it should continue to run until the temperature of the hydraulic pump returned to normal, so that it can prevent the external moisture, so that the internal components rusty.
7、清洗完气体增压系统后要及时把回路内的清洗油去除干净。
7 、 after cleaning the gas pressurization system, clean the cleaning oil in the circuit in time.
好了,小编今天就为大家简单介绍到这里啦!明天的咨询会更精彩哦!请大家不要错过哦!
Well, Xiao Bian today for everyone to brief introduction here! Tomorrow's consultation will be more wonderful! Please don't miss it!
新闻: