气体增压泵可以对空气、氮气、氧气、氢气等气体增压，如果为腐蚀性气体，如H2S,SO2等气体，在选型时客户需主动说明。那你知道气体增压泵运行前的过滤安装要求是怎样的吗？
The gas booster pump can pressurize air, nitrogen, oxygen, hydrogen and other gases. If it is a corrosive gas, such as H2S, SO2 and other gases, the customer should take the initiative to explain when selecting the model. Do you know what the installation requirements of the filter before the operation of the gas booster pump are?
气体增压泵过滤要求：
Filtering requirements of gas booster pump:
气体增压泵动力源为压缩空气，要求气源洁净，颗粒要求在5um以下，一般工厂气源比较脏，如果不经过滤直接接到泵上，长期使用，泵会长期积污，会导致单向阀失灵、密封圈磨损严重。
The power source of the gas booster pump is compressed air. The air source is required to be clean, and the particles are required to be less than 5um. Generally, the air source of the factory is dirty. If the pump is directly connected to the pump without filtering, and it is used for a long time, the pump will accumulate dirt for a long time, which will lead to the failure of the one-way valve and serious wear of the seal ring.
气体增压泵安装要求：
Installation requirements for gas booster pump:
安装时驱动气源建议使用PU风管，原因容易安装，操作方便，管内不会生锈，如果使用金属管，安装前建议用压缩空气吹扫，避免焊渣吹到换向阀内，将换向阀卡死。气体增压泵可以垂直安装或水平安装，在条件允许的情况下，建议垂直安装，垂直安装能延长密封件的使用寿命。
It is recommended to use PU air duct as the driving air source during installation, because it is easy to install and operate, and the pipe will not rust. If a metal pipe is used, it is recommended to use compressed air to purge before installation, so as to avoid welding slag blowing into the directional valve and jamming the directional valve. The gas booster pump can be installed vertically or horizontally. If conditions permit, vertical installation is recommended. Vertical installation can prolong the service life of the seal.
使用注意事项
Precautions
1、输出压力要相比自己要求的压力留有余量。
1. The output pressure should have margin compared with the pressure you require.
2、查看驱动气压范围，切勿超负荷使用。
2. Check the driving air pressure range, and do not overload.
3、产品入口压力有着严格的要求，入口压力过低，直接影响气体增压泵的流量及输出压力。
3. The inlet pressure of the product has strict requirements. If the inlet pressure is too low, it will directly affect the flow and output pressure of the gas booster pump.
4、增压介质的洁净，气体增压泵及现场使用环境的清洁、卫生。
4. The pressurizing medium shall be clean, and the gas booster pump and on-site service environment shall be clean and sanitary.
5、高压入口尽量加装过滤器，有利于减少杂质等对产品的影响。
5. High pressure inlet shall be equipped with filter as much as possible to reduce the impact of impurities on products.
6、使用前，驱动气源口处建议加配油水分离器，经常释放水杯内部的水分。
6. Before use, it is recommended to add an oil-water separator at the drive air supply port to regularly release the water inside the water cup.
Xiao Bian reminds you that after using the gas booster pump every time, you need to exhaust the high-pressure gas. In addition, the gas booster pump shall be checked regularly to maintain the integrity of parts. Come to our website for more information http://www.sdjingtuo.com Ask and understand!
