What to do if the gas-liquid booster pump suddenly doesn't work? What we use is a gas-liquid booster pump. What if the pneumatic liquid booster pump suddenly doesn't work? Sometimes when the partial pressure fails to reach the pneumatic liquid booster pump, some customers may encounter two problems. One is that the pneumatic liquid booster pump suddenly fails to work when it is working. The other is that the pressure is good at the beginning, but the pressure rises slowly or the pressure is basically not.
Then we make a detailed discrimination and Analysis on these two problems. There are two reasons why the pneumatic liquid booster pump suddenly does not work. One is the proportion between the output liquid pressure and the air pressure of the driving gas source. If the driving air pressure is 6 bar and the pressure ratio is 40:1, then the operation will be stopped when the output pressure reaches 40 * 6 = 240 bar. The other is that there is impurity in the driving air, which causes the sealing ring of the reversing valve to be stuck. There is another phenomenon that the piston at the driving end is scattered.
After working for a period of time, the pneumatic liquid booster pump found that the speed of pressure rise was slow, sometimes it could not put pressure, this time may be that there are impurities in the inlet and outlet check valve, so it needs to be cleared. If there is no effective treatment after liquidation, the internal high-pressure seal can be changed for disposal.
The above wonderful contents are supported by the gas-liquid booster pump manufacturer. There are many wonderful contents waiting for you to check. Welcome to continue to follow our website: http://www.sdjingtuo.com and look forward to your attention!