1、不能用火油、酒精或是其它腐蚀性液体，以防液压器元件、油箱等部件受到腐蚀，影响液压器的正常使用。
1. Fire oil, alcohol or other corrosive liquids should not be used to prevent corrosion of hydraulic components, oil tanks and other components, which will affect the normal use of hydraulic presses.
2、清洗气体增压体系时，液压泵工作和清洗介质加热应同时进行。因为，清洗油液的温度为五十摄氏度到八十摄氏度时，体系内的橡胶渣时很容易被除掉的。
2. When cleaning the gas supercharging system, the work of the hydraulic pump and the heating of the cleaning medium should be carried out simultaneously. Because when the temperature of cleaning oil is between 50 and 80 degrees Celsius, the rubber residue in the system can easily be removed.
3、液压泵工作的时分进行间歇性的工作能够进步清洗作用。
3. Intermittent work can improve the cleaning effect when hydraulic pump works.
4、咱们应该在气体增压体系的清洗油路的回路上装置过滤器，这样能够过滤掉体系内大部分的杂质。
4. We should install filters in the circuit of cleaning oil circuit of gas supercharging system, so that most impurities in the system can be filtered out.
5、清洗液压泵的时间一般在四十八小时到六十小时之间，这是由体系的杂乱程度和污染程度等因素决定的。
5. The cleaning time of hydraulic pump is generally between 48 hours and 60 hours, which is determined by the degree of disorder and pollution of the system.
6、清洗结束时，不要立即使液压泵停止工作，应该使其继续工作直到液压泵气温恢复正常，这样能够防止外界湿气使内部器材生锈。
6. At the end of the cleaning, do not stop the hydraulic pump immediately. It should continue to work until the temperature of the hydraulic pump returns to normal. This can prevent the external humidity from rusting the internal equipment.
7、清洗完气体增压体系后要及时把回路内的清洗油去除洁净。
7. After cleaning the gas supercharging system, the cleaning oil in the circuit should be removed in time.
为了延长气体增压体系的使用寿命，今后再清洗气体增压体系时就必定要注意上面提到的这些事项。
In order to prolong the service life of gas turbocharging system, it is necessary to pay attention to these matters mentioned above when cleaning gas turbocharging system in the future.
