实际上,储气罐连接
气体增压泵,能够储存一定压力的压缩气体,是有一定的危险性,所以在使用时要注意一些事。
In fact, the gas tank is connected to the gas booster pump, which can store compressed gas of a certain pressure. It is dangerous, so some things should be paid attention to when using it.
1、使用油水分离器。压缩空气作为驱动气体进入气体增压泵前须使用油水分离器去除冷凝水、油污或者杂质。
1. Use an oil-water separator. Before the compressed air enters the gas booster pump as the driving gas, the oil-water separator must be used to remove condensate, oil or impurities.
2、加装过滤器。预增气体(氢气、氮气、氦气等)通过增压后,可能也会有水凝结出来,并且气体增压泵内也会发生磨损,因此气体增压泵的气体输入口和高压输出口都须加过滤器。
2. Add filter. After the pre added gas (hydrogen, nitrogen, helium, etc.) is pressurized, water may also condense, and wear may also occur in the gas booster pump. Therefore, filters must be added to the gas inlet and high-pressure output of the gas booster pump.
3、如果,输出端用气设备内压力低于入口预增气压力时,设备可通过单向阀向设备内部直接充气,因此可节省充气时间。
3. If the pressure in the gas equipment at the output end is lower than the inlet pre inflation pressure, the equipment can directly inflate into the equipment through the one-way valve, so the inflation time can be saved.
4、安装储气罐。考虑到工况的不同,设备的输出高压力可预先储存到高压气罐中(气罐的容积大小请咨询技术工程师),根据用气设备的使用压力要求,使用减压阀来调节出口压力。
4. Install the air receiver. Considering the different working conditions, the high output pressure of the equipment can be stored in the high-pressure gas tank in advance (please consult the technical engineer for the volume of the gas tank). According to the operating pressure requirements of the gas equipment, the pressure reducing valve is used to adjust the outlet pressure.
5、气体增压泵入口侧压缩空气流量约为气体增压泵出口侧流量的2倍(增压设备的预增气体通过增压,中间会产生损耗)。
5. The compressed air flow at the inlet side of the gas booster pump is about twice the flow at the outlet side of the gas booster pump (the pre increased gas of the booster device will be lost in the middle through pressurization).
6、气体增压泵的寿命是由动作的频率决定。因此如果设备需要长时间运转,请在工况中说明,技术会讨论决定气体增压泵的类型,这样会大大增压气体增压设备的使用寿命期限。
6. The service life of the gas booster pump is determined by the action frequency. Therefore, if the equipment needs to operate for a long time, please explain in the working conditions. The type of gas booster pump will be discussed and determined by the technical meeting, which will greatly boost the service life of the gas booster equipment.
In addition, I remind you that the gas booster pump itself is also dangerous, so if you want to complete the work safely and smoothly, you should do a good job of inspection and maintenance before and after use. Follow us http://www.sdjingtuo.com Explain the new information for you!