由于风的渗透，空气中总是含有微小的灰尘和其他杂质。如果空气中的石灰和沙子杂质含量过高，使用相关的增压泵是有风险的。那么增压泵对驱动气体的清洁度有哪些要求呢？
Due to the penetration of wind, the air always contains tiny dust and other impurities. If the content of lime and sand impurities in the air is too high, it is risky to use the relevant booster pump. What are the requirements for the cleanliness of the driving gas of the booster pump?
硬砂会随着压缩空气的运动而磨损泵体、活塞环、活塞杆填料等部件，缩短机器的使用寿命；
Hard sand will wear the pump body, piston ring, piston rod packing and other components with the movement of compressed air, shortening the service life of the machine;
灰尘进入气泵并与润滑油混合，在气泵和活塞环内形成焦块。一方面，机械润滑会失效，另一方面，在相关增压泵高温多沙的环境中可能会引起爆炸；
Dust enters the air pump and mixes with lubricating oil to form coke blocks in the air pump and piston ring. On the one hand, the mechanical lubrication will fail; on the other hand, it may cause explosion in the high temperature and sandy environment of the relevant booster pump;
石灰砂进入气体增压泵时，容易堵塞气体阀门和气体管道，导致压缩设备不准确，甚减少出口流量；
When lime sand enters the gas booster pump, it is easy to block the gas valve and gas pipeline, resulting in inaccurate compression equipment and even reducing the outlet flow;
因为灰尘会增加气动增压泵的磨损，粉碎气动增压泵的润滑，影响空气气体的冷却，导致压缩空气的更终温度升高，具有一定的隐患。。
Because dust will increase the wear of pneumatic booster pump, pulverize the lubrication of pneumatic booster pump, affect the cooling of air and gas, and cause the final temperature of compressed air to rise, which has certain potential safety hazards..
因此，在空气或其他气体进入气动增压泵之前，必须通过装有过滤器的设备，防止灰尘和灰尘杂质进入气动增压泵，防止相关滑动部件磨损急剧增加，防止润滑。油的氧化。
Therefore, before air or other gases enter the pneumatic booster pump, it is necessary to prevent dust and dust impurities from entering the pneumatic booster pump through the equipment equipped with filter, so as to prevent the sharp increase of wear of relevant sliding parts and prevent lubrication. Oxidation of oil.
另外，
气体增压泵的使用注意事项有必要多了解一些，有利于以后的使用。例如，输出压力与自身所需的压力相比应有余量。高压进口处装有过滤器，以减少杂质对产品的影响。产品的进口压力要求严格，进口压力过低，直接影响气体增压泵的流量和输出压力。
In addition, it is necessary to know more about the precautions for the use of gas booster pump, which is conducive to future use. For example, the output pressure shall have margin compared with the pressure required by itself. A filter is installed at the high-pressure inlet to reduce the impact of impurities on the product. The inlet pressure of the product is strict, and the inlet pressure is too low, which directly affects the flow and output pressure of the gas booster pump.
加压介质的清洁度、气体增压泵的清洁卫生及现场使用环境。使用前，建议在驱动气源口安装油水分离器，经常将水杯内的水排出。因此，更多相关信息，您可以来关注我们的网站
www.sdjingtuo.com进行咨询！
Cleanliness of pressurized medium, cleanliness of gas booster pump and site use environment. Before use, it is recommended to install an oil-water separator at the drive air source port to often drain the water in the water cup. Therefore, for more information, you can follow our website www.sdjingtao Com for consultation!
