热线电话
0531-69951198
网站首页
关于精拓
产品展厅
新闻中心
原理选型
客户案例
在线留言
联系我们
网站公告:

新闻中心

济南精拓流体设备有限公司

电话:0531-69951198

邮箱:jingtuolt@163.com

传真:0531-69951198

地址:济南市历城区祝甸北路2号院

网址:http://www.sdjingtuo.com

企业动态

当前位置:首页 - 新闻中心 - 企业动态气体增压泵工作原理及使用

气体增压泵工作原理及使用注意事项!

发布时间:2021-10-11 11:52:13   发布人:http://www.sdjingtuo.com
气体增压泵是以压缩空气为动力源的一种活塞式增压泵,当进气时增压气控阀的阀芯往复切换工作,控制增压泵活塞以极快的速度作往复动作,随着输出压力的增高,活塞的往复速度减慢直停止,此时,增压泵输出的压力恒定,能量消耗低,各部件停止工作;无/何种原因造成保压回路压力下降,增压泵将自动启动,补充泄露压力,保持回路压力恒定。
The gas booster pump is a kind of piston booster pump with compressed air as the power source. When air is introduced, the valve core of the booster air control valve switches back and forth to control the booster pump piston to perform reciprocating action at a very fast speed. With the increase of output pressure, the reciprocating speed of the piston slows down until it stops. At this time, the output pressure of the booster pump is constant, the energy consumption is low, and all components stop working; If there is no reason for the pressure drop of the pressure maintaining circuit, the booster pump will start automatically to supplement the leakage pressure and keep the circuit pressure constant.
气体增压泵工作原理动态图
Dynamic diagram of working principle of gas booster pump
1-驱动空气入口;2-驱动空气管路;3-气动活塞;4-顶部撞针;5-先导阀口;6-换向阀;7-底部撞针;8-先导排气口;9-消声器;10-入口单向阀;11-出口单向阀
1 - drive air inlet; 2 - drive air pipeline; 3 - pneumatic piston; 4 - top striker; 5 - pilot valve port; 6 - directional valve; 7 - bottom striker; 8 - pilot exhaust port; 9 - silencer; 10 - inlet check valve; 11 - outlet check valve
气动气6增压泵一般用于产品气压测试、提升工厂局部气源压力等,在一次使用前,须详细阅读产品相关使用说明,切勿凭感觉操作。使用时,注意以下事项等,可用的更久。
Pneumatic 6 booster pump is generally used for product air pressure test and increasing the local air source pressure of the factory. Before one use, read the relevant instructions of the product in detail and do not operate by feeling. When using, pay attention to the following matters, which will be available for a longer time.
1、使用的环境粉尘不能太多,因为气动气体增压泵上的呼吸孔可能会把杂志吸入泵的腔体内6,进而可能会导致其上的密封圈机缸筒划伤等情况的发生,大大的缩减应有的使用寿命年限。
1. The use of environmental dust should not be too much, because the breathing hole on the pneumatic gas booster pump may suck the magazine into the cavity 6 of the pump, which may lead to scratches on the sealing ring and cylinder barrel, greatly reducing the due service life.
2、如有条件的,可通过加配油水分离器来达到过滤掉空气驱动气源中的杂质以及水分等,这对于延长综合使用年限都是很有帮助的。
2. If possible, add an oil-water separator to filter out impurities and moisture in the air driven air source, which is very helpful to prolong the comprehensive service life.
新闻: