热线电话
0531-69951198
网站首页
关于精拓
产品展厅
新闻中心
原理选型
客户案例
在线留言
联系我们
网站公告:

新闻中心

济南精拓流体设备有限公司

电话:0531-69951198

邮箱:jingtuolt@163.com

传真:0531-69951198

地址:济南市历城区祝甸北路2号院

网址:http://www.sdjingtuo.com

企业动态

当前位置:首页 - 新闻中心 - 企业动态增压比的气体增压泵应该符

增压比的气体增压泵应该符合怎样的标准?

发布时间:2019-06-17 16:26:36   发布人:http://www.sdjingtuo.com
气体增压泵的增压比:为驱动活塞与高压活塞(或柱塞)的面积比,这是一个决议泵输出压力的重要要素,关于一款泵,其增压比是固定的,其输出压力为驱动气压和增压比的乘积。客户只需求依据应用场所的压力请求来选择适宜增压比的产品即可。
Boost ratio of gas booster pump: In order to drive piston to high-pressure piston (or plunger) area ratio, it is an important factor to determine the output pressure of pump. For a pump, the boost ratio is fixed, and its output pressure is the product of drive pressure and boost ratio. Customers only need to select the products with suitable boost ratio according to the pressure request of the application site.
二、怎样选择适宜增压比的气体增压泵产品?
2. How to choose the gas booster pump products with suitable boost ratio?
直接举例如下:
Direct examples are as follows:
1、某客户如今的气源压力为6bar,要提升到30bar供新进设备运用,30除以6=5,也就是采用我司的5倍气体增压泵即可把气源压力提升到30bar。当然,选型的时分还有一个重要的要素:高压后流量请求;由于此客户高压后流量请求为6L/min,我司的5倍气体增压泵高压后流量为7L/min,能够满足其高压后流量请求,如不满足的也不能够采用。
1. The pressure of a customer's gas source is 6bar, which should be raised to 30bar for new equipment. 30 divided by 6 = 5, that is to say, the pressure of the gas source can be raised to 30bar by using our 5 times gas booster pump. Of course, there is also an important factor in the selection: the flow request after high pressure; because the customer's flow request after high pressure is 6L/min, the flow of our company's 5 times gas booster pump after high pressure is 7L/min, which can satisfy the flow request after high pressure, and can not be used if it is unsatisfactory.
2、某公司车间之前气源压力在6bar的状况下,都能够满足大局部设备消费运用;但近期采购了一台需求更大气压(10bar)的设备。计划有2个,采购一台大的空气紧缩机和采购一台气体增压泵,明显,前者由于本钱过高且噪音过大,后选择了后一个计划。
气体增压泵
2. Under the condition of 6 bar air pressure before the workshop of a company, most of the equipment can be consumed and used. But recently, a equipment with 10 bar air pressure was purchased. There are two plans. One is to purchase a large air compressor and the other is to purchase a gas booster pump. Obviously, the former is too expensive and noisy. Finally, the latter plan is chosen.
计划施行:客户目前气源压力为6bar,需求提升到10bar,我司就给客户引荐运用2倍的气体增压泵产品(目前的气源压力6bar乘以2=12bar,契合10bar气源压力请求)。当然,还有一个问题就是能否对高压后流量有特殊请求,我司2倍的气体增压泵可细分为大2倍和小2倍的,区别在于高压后的流量,大2倍的有80L/min,小2比的为40L/min。
Plan implementation: Customer's current gas pressure is 6 bar, the demand is raised to 10 bar, our company will recommend to customers the use of 2 times the gas booster pump products (the current gas pressure 6 bar multiplied by 2 = 12 bar, meet the 10 bar gas pressure requirements). Of course, there is another question is whether there is a special request for the flow rate after high pressure. Our gas booster pump can be subdivided into two times larger and two times smaller. The difference is that the flow rate after high pressure is 80 L/min for two times larger and 40 L/min for two times smaller.
注:由于气体增压泵增压比越高,其对应请求的入口压力也高,所以广阔客户在选型和运用的时分,请留意被增压气体的小入口压力。
Note: Because the higher the boost ratio of the gas booster pump, the higher the inlet pressure corresponding to the request, so when the customers choose and use, please pay attention to the minimum inlet pressure of the pressurized gas.
以上就是气体增压泵http://www.sdjingtuo.com 为大家介绍的内容,感谢您在百忙之中查看我公司的信息内容,如果您想要了解的更多,欢迎您来电进行咨询!
This is the content of the gas booster pump http://www.sdjingtuo.com. Thank you for checking the information content of our company in your busy schedule. If you want to know more, you are welcome to call for consultation!
新闻: