The pneumatic booster pump uses low pressure gas actuated by a large piston end to generate low pressure fluid at the piston end of a small area. It can be used to constract air and other gases. The input air pressure can be adjusted by driving air pressure.
The flow rate of the gas booster pump is large as long as 0. 3-0. 69MPa contraction air drive can achieve larger input flow. Active Pressure Keeping: When the task, the agile stop task, as the input pressure close to the set pressure value when the reciprocating static speed of the pump slows down until the stagnation.
And maintain this pressure, at this time consumption energy is very small, no hot gas booster pump volume occurs, no parts static. When the pressure balance breaks through, the pneumatic booster pump starts the task to the next balance. Excellent material: low pressure local material is stainless steel. Low pressure plunger material is stainless steel and adopts double-layer seal. Simple protection: the parts and seals of the pneumatic booster pump are few, and the protection is simple and low. With all the "O" rings of the series pumps, the wearing parts of the repair bags can be exchanged with each other, which greatly reduces the old version. The pneumatic booster pump has been filled with a smoothing agent before the plant is released. Maintenance of hydraulic pressure does not need to consume energy.
With explosion-proof function, no power or wiring connection itself is safe and compact, lightweight and free from meteorological changes. Easy to complete the initiative, anti purification. The input dynamic pressure is adjusted by the driving pressure. The input pressure of 80000PSI is very easy to start and stop operation at full load, easy to install and operate.