热线电话
0531-69951198
网站首页
关于精拓
产品展厅
新闻中心
原理选型
客户案例
在线留言
联系我们
网站公告:

新闻中心

济南精拓流体设备有限公司

电话:0531-69951198

邮箱:jingtuolt@163.com

传真:0531-69951198

地址:济南市历城区祝甸北路2号院

网址:http://www.sdjingtuo.com

网站公告

当前位置:首页 - 网站公告二氧化碳增压泵操作安装的

二氧化碳增压泵操作安装的流程

发布时间:2018-02-23 18:27:53   发布人:http://www.sdjingtuo.com
1. 安装:安装过程中,请参考技术参数中的各接口尺寸,避免异物进入泵内,保持进出口的清洁
1. installation: in the process of installation, please refer to the interface dimensions of the technical parameters, avoid the foreign objects into the pump, and keep the import and export clean.
2. 气源质量标准:请选择洁净气源,以保证泵能持续稳定的工作。
2. gas source quality standard: please choose the clean gas source to ensure the continuous and stable work of the pump.
3. 气源润滑:泵在出厂时,所有运动部分已经抹有适量润滑油,一般不再需要润滑,如长期使用干燥的压缩气体驱动,建议在二联体的油杯内加入适量的润滑油,进行油雾润滑
3. air lubrication: pump at the factory, all moving parts have put a proper amount of lubricating oil, no longer need lubrication, such as the long-term use of dry compressed air driven, suggested adding amount of the lubricating oil in the oil cup two cis, for oil mist lubrication
气体增压泵
4. 气源压力:该泵的小驱动压力为1.5-2bar较大设计驱动压力为10bar。建议使用气压在6-8bar之间。可通过调整调压阀的压力,以达到需求的使用压力。泵的驱动压力不能超过10bar如果是通过管道气进行驱动的,一定有可靠的减压阀及阀。
4. gas pressure: the minimum driving pressure of the pump is 1.5-2bar maximum design drive pressure of 10bar. It is suggested that air pressure is used between 6-8bar. The pressure of the pressure regulating valve can be adjusted to meet the demand pressure. The driving pressure of the pump must not exceed 10bar. If it is driven through the pipe gas, there must be a reliable pressure relief valve and safety valve.
5.连接管路:根据泵的输出压力、流量,选择合适的进出口连接管路,确保能承受泵的较大输出压力、流量。
5. connection pipeline: according to the pump output pressure, flow, select the appropriate import and export connection pipeline, to ensure that the pump can bear the maximum output pressure, flow.
6、泵的较大输出压力由驱动气气源压力决定,按增压泵的增压比计算,增压比为25:1,则在驱动气气源压力为6bar时,泵的较大输出压力为6х25=150bar输出压力随气源压力无极调节。
The maximum output pressure of 6, the pump is controlled by driving gas pressure booster, booster pump according to the ratio, pressure ratio was 25:1, the driving gas pressure is 6bar, the maximum output pressure of the pump is 6 25=150bar output pressure with air pressure were no adjustment.
相信看了本文的介绍后,对 气体增压泵http://www.sdjingtuo.com这方面也会有自己的一番认识,以后针对的等问题也能很好的解决。
I believe that after seeing the introduction of this article, we will have some understanding of the http://www.sdjingtuo.com of gas booster pump. Later, we can solve some other problems well.
新闻: